2003 · 159 citations · 15 references
EngineeringComputer EngineeringElectrical EngineeringInstrumentationMicroelectronicsSemiconductor DevicesBuilt-in Self-testDefect DetectionDesign For TestabilityDevice CharacterizationDevice ReliabilityDevice ScalingComparator ValidityCurrentsDynamic ThresholdsElectrical TestabilityProcess Variation CharacterizationSignal ThresholdsThresholdsValidation Against Production Data
The use of a single pass/fail threshold for I/sub DDQ/ testing is unworkable as chip background currents increase to the point where they exceed many defect currents. This paper describes a method of using "current signatures" which uses only simple comparisons on the tester, and which automatically scales with process variations which give a wide range of background currents. Dynamic thresholds are used, based on the ratio of maximum to minimum current. Using a single I/sub DDQ/ measurement for each die, upper and lower comparator values are set, against which I/sub DDQ/ for each vector in the suite is compared. Production data is presented to verify the validity of the method.
15
Iddq test: sensitivity analysis of scaling
T.W. Williams, R.H. Dennard, R. Kapur et al. · 2002 · 152 citations
Engineering, Computer Engineering, Electrical Engineering +17
Current signatures [VLSI circuit testing]
Anne Gattiker, W. Maly · 2002 · 121 citations
Engineering, Computer Engineering, Electrical Engineering +11
Current signatures: application
Anne Gattiker, W. Maly · 2002 · 117 citations
Engineering, Computer Engineering, Electrical Engineering +15