IEEE Transactions on Components Packaging and Manufacturing Technology · 2018 · 17 citations · 12 references
EngineeringElectrical EngineeringManufacturing EngineeringMicroelectromechanical SystemsMicroelectronicsMicrofabricationMems DesignMems FabricationMems SwitchesMicrofabrication ProcessesMicromachiningRf MemsFabricationMicroelectromechanical System FabricationMicroswitchesPolymers In Mems FabricationRf Mems FabricationRf Mems SwitchesRf Microelectromechanical SystemsSwitch Fabrication Processes
This paper presents a low-cost microfabrication technique for manufacturing radio frequency microelectromechanical system (RF MEMS) switches and varactors without intensive clean-room environments. The fabrication process entails only laser microstructuring technique, non-clean-room microlithography, and standard wet-bench and hot-film emboss of SU-8 and ADEX polymers. MEMS movable structures were fabricated out of 14- <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> -thick aluminum foils and suspended above coplanar-waveguide transmission lines, which were implemented on top of FR4 substrates via 5- <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> -thick SU-8 dielectric anchors. Both MEMS structures and an FR4 substrate were integrated using micropatterned polymers, developed by using dry-film ADEX and SU-8 polymers, for a composite assembly. An average fabrication yield of higher than 60% was achieved, calculated from 10 fabrication attempts. The RF measurement results show that the RF MEMS devices fabricated by using the novel microfabrication process have good figures of merit, at much lower overall fabrication costs, as compared to the devices fabricated by conventional clean-room process, enabling it as a very good microfabrication process for cost-effective rapid prototyping of MEMS.
12
SU-8: a low-cost negative resist for MEMS
H. Lorenz, M. Despont, N. Fahrni et al. · Journal of Micromechanics and Microengineering · 1997 · 972 citations · Full text
Design of low actuation voltage RF MEMS switch
Sergio Pacheco, L.P.B. Katehi, Clark T.‐C. Nguyen · 2002 · 249 citations
Water‐Soluble Sacrificial Layers for Surface Micromachining
Vincent Linder, Byron D. Gates, Declan Ryan et al. · Small · 2005 · 207 citations