Journal of Applied Physics · 1987 · 23 citations · 10 references
EngineeringElectrical EngineeringPhysicsElectronic MaterialsSemiconductor DevicesSemiconductor MaterialsDefects In Electronic MaterialsDopingNoise In Electronic DevicesNoise In Semiconductor DevicesSemiconductor Device MaterialsSemiconductor PhysicsCarrier ConcentrationHall EffectIon Implantation EffectsLattice DamageNoise In ResistorsResistorsTemperature DependenceTrap Levels
The conductivity, the Hall effect, and the noise of ion-implanted resistors is measured between 77 and 300 K. The temperature dependence of the carrier concentration in these boron-doped layers cannot be explained by the freeze-out of the boron acceptor level. Possible explanations are a temperature-dependent Hall factor r and a distribution of trap levels 0.1–0.2 eV above the valence-band edge. The mobility μ can be determined from the conductivity and the Hall-effect data. The mobility shows the highest value after annealing at 750 °C. The value of the 1/f noise parameter α shows a weak temperature dependence after annealing at 450, 550, 650, and 900 °C. After annealing at 750 °C the α value decreases from 10−5 at 300 K to lower than 2×10−7 at 77 K. The highest mobility μ gives the lowest 1/f noise parameter α. This indicates that more defects and lattice damage give more 1/f noise. Additional scattering mechanisms have much more influence on the 1/f noise parameter α than on the mobility μ.
10
Experimental studies on 1/f noise
F.N. Hooge, T.G.M. Kleinpenning, L.K.J. Vandamme · Reports on Progress in Physics · 1981 · 1.1K citations
Theoretical analysis of hall factor and hall mobility in p-type silicon
Jan-Hai Lin, Shuguang Li, Luis Carlos Linares et al. · Solid-State Electronics · 1981 · 123 citations