AIMS Materials Science · 2018 · 11 citations · 16 references
Natural SciencesChemical EngineeringMaterials ScienceSurface ChemistrySurface EngineeringSurface ScienceCatalysis At SurfacesSurface CatalysisSurface Finish QualitySurface FinishingSurface OxidationSurface ReactionsChemical FinishingFenton ReactionImmersion CorrosionMagnetorheological MaterialsOxidationSilicon CarbideSilicon Carbide (Sic) MaterialsSurface Roughness Analysis
Aiming at the chemical magnetorheological finishing (CMRF) of single crystal silicon carbide (SiC) based on the Fenton reaction, concentration of hydroxyl radical produced in Fenton reaction and its influence on chemical reaction rate of SiC were detected by visible spectrophotometry, and catalytic ability of different particles was detected by the method of immersion corrosion test. The experimental results showed that surface roughness is better when the carbonyl iron powder (CIP) is used as catalyst. The lower value of pH, the higher content of hydroxyl radicals. The hydroxyl radical can react with SiC surface to form a softer SiO<sub>2</sub> oxide layer. The acid environment can promote Fenton reaction and the polishing effect is better, while the oxidation layer of SiC surface is converted to silicate in the alkaline environmental. The SiC after CMRF can obtain the smooth surface of the surface roughness Ra 0.0817 nm when the pH value is 9.
16
Chemomechanical Polishing of Silicon Carbide
Ling Zhou, V. Audurier, Pirouz Pirouz et al. · Journal of The Electrochemical Society · 1997 · 211 citations