IEEE Sensors Journal · 2003 · 115 citations · 17 references
EngineeringElectrical EngineeringMechanical EngineeringMicroelectromechanical SystemsMicrofabricationSensorsMems CharacterizationMems DesignMems FabricationMems SensorsMicromachiningVibration MeasurementCoriolis AccelerationDeep Reactive Ion EtchingGyroscope CharacterizationGyroscopesIsolationMicroelectromechanical SpringsNoise FloorSilicon Micromachining
A gyroscope with a measured noise floor of 0.02°/s/Hz <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">1</sup> 2/ at 5 Hz is fabricated by post-CMOS micromachining that uses interconnect metal layers to mask the structural etch steps. The 1 × 1 mm lateral-axis angular rate sensor employs in-plane vibration and out-of-plane Coriolis acceleration detection with on-chip CMOS circuitry. The resultant device incorporates a combination of 1.8-μm-thick thin-film structures for springs with out-of-plane compliance and 60-μm-thick bulk silicon structures defined by deep reactive-ion etching for the proof mass and springs with out-of-plane stiffness. The microstructure is flat and avoids excessive curling, which exists in prior thin-film CMOS-microelectromechanical systems gyroscopes. Complete etch removal of selective silicon regions provides electrical isolation of bulk silicon to obtain individually controllable comb fingers. Direct motion coupling is observed and analyzed.
17
A micromachined comb-drive tuning fork rate gyroscope
Jonathan Bernstein, S. Cho, A. Thomas King et al. · 2002 · 283 citations
Engineering, Electrical Engineering, Mechanical Engineering +11
A post-CMOS micromachined lateral accelerometer
Hao Luo, Gang Zhang, L.R. Carley et al. · Journal of Microelectromechanical Systems · 2002 · 154 citations
Engineering, Electrical Engineering, Mechanical Engineering +17