Japanese Journal of Applied Physics · 1995 · 13 citations · 7 references
Natural SciencesMaterials EngineeringMaterials ScienceSemiconductor MaterialsSurface ChemistrySurface ScienceEtching ProcessesPlasma-surface InteractionsSemiconductor SurfacesSurface ModificationSurface PhysicsX-ray Photoelectron SpectroscopyEtch MechanismsEtch RateEtchingOptical Emission SpectroscopyPlasma EtchingSilicon DioxideSilicon EtchingSurface Etching
The increase in poly-Si etch rate at low O 2 concentration (1-5%) in Cl 2 /O 2 plasmas was investigated using optical emission spectroscopy (OES) and X-ray photoelectron spectroscopy (XPS). The OES spectrum indicates that the Cl (837.5 nm) intensities increase at low O 2 concentration during the poly-Si etching but the dissociation of Cl 2 is not promoted by the addition of O 2 to Cl 2 . SiCl (287 nm) intensities decrease in the range of O 2 concentration where poly-Si etch rate increases. The result of XPS shows that by increasing O 2 concentration from 0% to 3%, the amount of Cl and O adsorbed onto poly-Si surface decreases and increases, respectively. In Cl 2 /O 2 plasmas, a cause of the poly-Si etch rate increase may be that oxygen atoms adsorb more easily on the poly-Si surface than chlorine atoms, and this weakens the Si-Si back bonds.
7
Handbook of chemistry and physics
Journal of the Franklin Institute · 1930 · 11.7K citations
Chih‐Chia Cheng, K. Guinn, Vincent M. Donnelly et al. · Journal of Vacuum Science & Technology A Vacuum Surfaces and Films · 1994 · 96 citations