Materials science forum · 2005 · 330 citations · 17 references
Natural SciencesMaterials EngineeringMaterials ScienceElectronic MaterialsMicroelectromechanical SystemsThin FilmsChemical Vapor DepositionMems FabricationMems MaterialsMems PackagingThin Film Mechanical PropertiesThin-film DepositionIntegration Of Mems ComponentsLow-temperature MaterialsMultilayer StacksStress CompensationStress Engineering In Thin FilmsStress Management In PackagingStructural Layer DepositionThin-film Stress Control
It is difficult to meet all the different material and economical requirements posed to a MEMS structural layer that can be integrated with the electronics on the same substrate using a single layer process. Therefore a multilayer process, which uses a combination of a CVD crystallization layer and a high-growth rate PECVD bulk layer was developed. High-quality films with excellent electrical and mechanical properties can be obtained at low temperature (#450°C) and high deposition rates (~100 nm/min). Fine-tuning of the stress gradient is accomplished by the use of a top stress compensation layer, whose optimal thickness was estimated from an evaluation of the stress gradient profile over thickness. These layers have been used for processing a 10 µm thick poly-SiGe gyroscope on top of a standard 0.35 µm CMOS process.
17
Thermal Conductivity of Ge-Si Alloys at High Temperatures
B. Abeles, D. S. Beers, George D. Cody et al. · Physical Review · 1962 · 203 citations