Challenges and Limitations of CMOS Scaling for FinFET and Beyond Architectures

Abstract

Scaling trends of FinFET architecture, with focus on Front-End-of-Line (FEOL), and Middle-of-Line (MOL) device parameters, is systematically investigated. It is concluded that the combined requirements of device electrostatics together with the demands on contact resistance, presents a Contacted-Gate-Pitch (CGP) scaling limit for horizontal-transport FETs. FET drive is expected to significantly degrade below this CGP ~ 40 nm as a result. Good agreement between hardware data and TCAD simulations is achieved and employed to estimate the contact resistance values for aggressively scaled FinFETs. These observations show that FinFETs scaled below CGP of 40 nm will require the contact resistivity (ρ <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">C</sub> ) of ~8 × 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-10</sup> Ω-cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> , while fully ohmic contacts i.e., ρ <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">C</sub> of ~1 × 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-10</sup> Ω-cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> will be required if FinFETs are to extend performance below CGP of 30 nm. Ultimately, transition to new device architectures in which contact area is independent of CGP and/or Fin-Pitch will be necessary.