Experimental and numerical studies of injection molding with microfeatures

Abstract

Abstract Injection molding with microstructures was investigated both experimentally and theoretically. A series of injection molding experiments with PP and PMMA was carried out in a long and a short rectangular mold containing microchannels with the thickness of either 50 or 100 μm and an aspect ratio of 5. The filling lengths in the microchannels were affected by injection speed, mold temperature, and channel location. A high injection speed or high mold temperature resulted in a longer filling length. The filling length in the microchannels decreased as the filling time in the main flow region increased. All filling lengths can be merged into a single curve vs. Fourier number based on the microchannel thickness. Comparison was also made between the experimental measurements and numerical simulation. The mold/melt heat transfer coefficient was found to be a critical factor in determining the filling lengths. The local heat transfer coefficient provided a much better agreement than a constant heat transfer coefficient. POLYM. ENG. SCI., 45:866–875, 2005. © 2005 Society of Plastics Engineers