Virtual Community of Pathological Anatomy (University of Castilla La Mancha) · 2002 · 20 citations · 0 references
EngineeringGeoinformaticsGeodesyGlobal Navigation Satellite SystemsRemote SensingAttitude DeterminationCalibrationPhotogrammetric SurveyingPhotogrammetrySensor CalibrationSpatial CalibrationAerial PhotogrammetryBlock AdjustmentCalibration Of Sensor FramesGlobal OrientationOffset AccountingPhotogrammetric Block AdjustmentSensor Orientation EstimationUnmanned Aerial Vehicle Photogrammetry
System calibration is required in integrated IMU/GPS systems to account for the spatial offset and misalignment between IMU, GPS and camera frames; synchronization is to be maintained, to predict IMU/GPS position and orientation data at the mid-exposure time of the images. To this aim, measurement on the ground, complemented by a calibration flight over a test field, are performed. Depending on the mathematical model, a two steps or a single step procedure may be used to recover the calibration parameters. Within the OEEPE test “Integrated Sensor Orientation” the authors proposed a simple but effective two steps procedure, where calibration parameters are computed as a weighted average of the discrepancies between the EO parameters of the images derived from block adjustment and those computed from the IMU/GPS data. Here a new single step calibration procedure is presented, where the calibration parameters are explicitely inserted in the collinearity equations and the IMU/GPS data are considered as pseudo-observed quantities, replacing EO parameters as unknowns in the block adjustment. Applied to the same OEEPE data set , the new procedure yields the same results of the previous one, with less ground control points.