Effect of rapid mold surface inducting heating on the replication ability of microinjection molding light‐guided plates with V‐grooved microfeatures

Abstract

Abstract This study applies a magnetic induction heating method for rapid and uniform heating of a mold surface for injection molding of 2‐inch light‐guided plates (LGPs). Mold temperature is an important process parameter that affects microinjection molding quality. This research investigates the effects of high‐mold surface temperature generated by induction heating in enhancing the replication rate of microfeatures of LGPs. This study has three stages. First, an appropriate power rate setting is determined for induction heating and injection molding process window. Second, all key parameters affecting microfeature quality are identified to determine the optimum LGP micromolding parameters using the Taguchi and ANOVA methods. Third, the quality of microfeature heights and angles are experimentally verified. Polymethyl methacrylate was molded under various injection molding conditions to replicate an electroformed nickel stamper with V‐grooves 10 μm in width and 5 μm in depth. In this investigation, injection speed was set in the conventional range. Experimental findings indicate that instead of high‐mold temperature, the combination of low mold temperature and high surface temperature obtained using induction heating improve replication quality and reduce cycle time. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010