Precision Positioning of Wafer Scanners Segmented Iterative Learning Control for Nonrepetitive Disturbances

Sandipan Mishra, Joshua Coaplen, Masayoshi Tomizuka

IEEE Control Systems · 2007 · 54 citations · 7 references

Concepts

Abstract

Photolithography is a step in semiconductor manufacturing that uses a laser beam to transfer a pattern from a mask to the surface of a silicon wafer. This process is implemented by an optomechanical device called a wafer scanner (Figure 1). A schematic of the major subsystems of a wafer scanner is shown in Figure 2. The illumination system consists of an argon-fluoride (Ar-F) or similar laser source that passes a laser beam through the photomask mounted on the reticle to form an image of the integrated circuit (IC) on the silicon wafer mounted on the wafer stage. The reduction lens assembly projects a reduced image of the photomask, shown in Figure 3, onto a photoresist layer on the silicon wafer, shown in Figure 4. Linear motors are used to position the wafer and reticle scanning stages relative to the projection lens and illumination system. Although several individual ICs are typically made from a single silicon wafer, the scanner exposes only a small part of the wafer to the laser beam in a single scan. The scan is performed by simultaneously moving the wafer and reticle stages in opposite directions, which reduces the time required for a single scan, while keeping peak velocities of both stages small. After the length of the reticle is scanned, the stages are stepped to the required positions for the scan process at another location on the wafer. This step and scan process is illustrated in Figure 5. The critical dimension (CD) of the IC manufacturing process is the finest line resolvable on the silicon wafer by the scanner. The CD of the scanner depends on the type of optical assembly, laser source, and positioning accuracies of the wafer and reticle stages. State-of-the-art scanners using Ar-F lasers can achieve CDs as small as 65 nm. In addition to the CD, the standard deviation of line size is a performance metric for the wafer scanner. This metric, called the alignment accuracy, indicates how close two features can be reliably placed on the silicon wafer. One of the

References

7