IEEE Transactions on Electronics Packaging Manufacturing · 2006 · 31 citations · 6 references
EngineeringMaterials EngineeringMaterials ScienceElectronic MaterialsManufacturing ProcessesMaterials ProcessingFabrication MaterialsIntegrated Circuit FabricationMachiningMicrofabrication MaterialsSubstrate PreparationWafer BondingAtomic Force Microscopy AnalysisDiceDie AttachEnergy Dispersive X-ray SpectroscopyEnergy-dispersive X-ray SpectroscopyFillersSilicon Wafer ProcessingWafer Dicing
Thin wafers of 100-/spl mu/m thickness laminated with die-attach film (DAF) was diced using a standard sawing process and revealed a low chipping crack resistance. Wafers laminated with conductive DAF shows greater chipping compared to nonconductive DAF and bare silicon wafer. It was found through scanning electron microscopy (SEM) micrographs, energy dispersive X-ray (EDX) analysis, and atomic force microscopy (AFM) that silver fillers in the conductive DAF was the cause of excessive blade loading which resulted in bad chipping quality. To reduce chipping/cracking induced by sawing, an alternative double-pass sawing method was developed and is explained in the paper. The methodology of this study discusses a double-pass method, where the first pass dice through the wafer and varied the percentage of DAF thickness cut. Best results were achieved when dicing through the wafer and 0% of DAF, followed by a full separation in the second pass. Approximately 80% of chipping reduction compared to conventional single pass.
6
Optimizing the wafer dicing process
Udi Efrat · 2002 · 31 citations
Engineering, Manufacturing Engineering, Manufacturing Processes +15
Die cracking in flip chip assemblies
Mukesh Ranjan, Lavanya Gopalakrishnan, K. Srihari et al. · 2002 · 28 citations
Mechanical failure strength characterization of silicon dice
Desmond Y. R. Chong, W.E. Lee, J.H.L. Pang et al. · 2004 · 15 citations