2013 · 31 citations · 10 references
EngineeringElectrical EngineeringMaterials ScienceMicroelectromechanical SystemsNanotechnologySensorsMems DesignMems MaterialsMems SensorsMicroelectromechanical SensorsNanoelectromechanical SystemsVacuum PackagingAccelerometer MaterialsAccelerometersDampingElectromechanical CouplingMicrofabricated Capacitive SensorsMicrofabricated SensorsMicromachined SensorsNano Sensors
This paper reports on the design, implementation and characterization of triaxial capacitive accelerometers operating in a low-pressure environment (~1 Torr). Small form-factor devices, with proof-mass area of less than 1mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> , were fabricated on a 40 μm-thick SOI substrate using the HARPSS™ process to attain in-plane and out-of-plane nanoscale capacitive airgaps (~300 nm). Increased sensitivity and stable open-loop operation were simultaneously achieved by using additional damping electrodes. Large electromechanical coupling provided by the deep sub-micron airgaps allow for the design of high-frequency accelerometers (~15 kHz) that yield better shock and vibration immunity. Scale factors of 7.5 mV/g and 8.7 mV/g were measured for the in-plane (X/Y-axis) and out-of-plane (Z-axis) accelerometers, respectively, with measured cross-axis sensitivity of less than 0.5 % for accelerations of up to ±6g.
10
Micromachined inertial sensors
N. Yazdi, Farrokh Ayazi, K. Najafi · Proceedings of the IEEE · 1998 · 1.8K citations
Engineering, Electrical Engineering, Mechanical Engineering +17