Surface and Coatings Technology · 2021 · 27 citations · 38 references
Natural SciencesMaterials SciencePhysicsElectronic MaterialsSurface ScienceThin FilmsDielectricsSemiconductor Thin FilmsSurface PhysicsThin Film Electrical PropertiesThin-film DepositionThin-film MaterialsCapacitanceCapacitive CouplingFilm Growth MechanismsMagnetron SputteringSurface PotentialThin Oxide FilmsThin-film Growth Mechanisms
Bipolar high-power impulse magnetron sputtering (HiPIMS) is used to achieve ion acceleration for ion bombardment of dielectric thin films . This is realized by increasing the plasma potential ( U p ), during the interval in-between the HiPIMS-pulses, using a positive reversed voltage ( U rev ). As long as the film surface potential ( U s ) is maintained low, close to ground potential, this increase in U p results in ion-acceleration as ions approach the film surface. The effect of U rev on the ion bombardment is demonstrated by the growth of dielectric (Al,Cr) 2 O 3 films on two sets of substrates, Si (001) and sapphire (0001) utilizing a U rev ranging from 0 to 300 V. A clear ion bombardment effect is detected in films grown on the conductive Si substrate, while no, or a very small, effect is observed in films grown on the dielectric sapphire substrate . This is ascribed to the changes in U s when the substrate is subjected to the bombardment of positive ions . For a film surface that has a high capacitance to ground, U s remains close to ground potential for an extended time in-between the HiPIMS pulses, while if the capacitance is low, U s quickly attains floating potential ( U float ) close to U p . The simulated temporal evolutions of U s for the films by using capacitors show that for a 1 μm thick (Al,Cr) 2 O 3 film on a conductive substrate, U s is maintained close to ground potential during the entire 20 μs that U rev is applied after the HiPIMS pulse. On the other hand, when a capacitance corresponding to the 0.5 mm thick sapphire substrate is used, U s rapidly attains a potential close to U rev .
38
The Scherrer Formula for X-Ray Particle Size Determination
A. L. Patterson · Physical Review · 1939 · 8.9K citations
Review Article: Stress in thin films and coatings: Current status, challenges, and prospects
G. Abadias, Eric Chason, Jozef Kečkéš et al. · Journal of Vacuum Science & Technology A Vacuum Surfaces and Films · 2018 · 820 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +17
Crystallization behavior of thin ALD-Al2O3 films
S. Jakschik, Uwe Schroeder, T. Hecht et al. · Thin Solid Films · 2003 · 272 citations
Natural Sciences, Materials Engineering, Materials Science +14