Heterogeneous integration of contact-printed semiconductor nanowires for high-performance devices on large areas

Fengyuan Liu, William Taube Navaraj, Adamos Christou, Dhayalan Shakthivel, Ravinder Dahiya

Microsystems & Nanoengineering · 2018 · 86 citations · 46 references

DOIFull text

Open access

Concepts

TL;DR

The authors developed a contact‑printing system that transfers bottom‑up and top‑down semiconductor nanowires while preserving their as‑grown electronic properties, and analyzed how contact force governs heterogeneous integration of ZnO and Si NWs. The close‑loop printing system is controlled by contact pressure and sliding speed, and is used to fabricate ZnO and Si nanowire ultraviolet photodetectors in a Wheatstone bridge configuration on rigid and flexible substrates. The printed layers exhibit high nanowire densities (7 NW µm⁻¹ for ZnO, 3 NW µm⁻¹ for Si), tight packing (~115 nm diameter, 165 nm spacing) and 90 % alignment, yielding UV photodetectors with >10⁴ photocurrent‑to‑dark‑current ratio, reduced thermal drift, and uniform response.

Abstract

In this work, we have developed a contact-printing system to efficiently transfer the bottom-up and top-down semiconductor nanowires (NWs), preserving their as-grown features with a good control over their electronic properties. In the close-loop configuration, the printing system is controlled with parameters such as contact pressure and sliding speed/stroke. Combined with the dry pre-treatment of the receiver substrate, the system prints electronic layers with high NW density (7 NWs/μm for bottom-up ZnO and 3 NWs/μm for top-down Si NWs), NW transfer yield and reproducibility. We observed compactly packed (~115 nm average diameters of NWs, with NW-to-NW spacing ~165 nm) and well-aligned NWs (90% with respect to the printing direction). We have theoretically and experimentally analysed the role of contact force on NW print dynamics to investigate the heterogeneous integration of ZnO and Si NWs over pre-selected areas. Moreover, the contact-printing system was used to fabricate ZnO and Si NW-based ultraviolet (UV) photodetectors (PDs) with Wheatstone bridge (WB) configuration on rigid and flexible substrates. The UV PDs based on the printed ensemble of NWs demonstrate high efficiency, a high photocurrent to dark current ratio (>104) and reduced thermal variations as a result of inherent self-compensation of WB arrangement. Due to statistically lesser dimensional variations in the ensemble of NWs, the UV PDs made from them have exhibited uniform response.

References

46