Journal of Applied Physics · 1992 · 362 citations · 16 references
Natural SciencesMaterials EngineeringMaterials ScienceElectronic MaterialsSemiconductor MaterialsThin FilmsElectrical CharacterizationElectrical ConductivitySemiconductor Thin FilmsThin Film Electrical PropertiesThin-film DepositionThin-film MaterialsCrystallinity ChangesDoping In Thin FilmsIndium Tin Oxide Thin FilmsMagnetron SputteringSurface SegregationThin Oxide FilmsTin-doped Indium OxideX-ray Diffraction Analysis
The study aimed to identify the key factors enabling low resistivity in tin‑doped indium oxide films. Low‑resistivity ITO films were fabricated by low‑voltage dc magnetron sputtering and highly dense plasma‑assisted electron‑beam evaporation, and their structural properties were examined by XRD, SEM, and EDS to compare with conventional deposition methods. Reducing plasma impedance and sputtering voltage lowered resistivity from 1.92 to 1.34×10⁻⁴ Ω cm by increasing carrier density, while LVMS produced higher crystallinity and more active species, and HDPE yielded a flat surface with less tin segregation and the lowest resistance of 1.23×10⁻⁴ Ω cm.
Tin-doped indium oxide (ITO) films with the resistivity less than 1.35×10−4 Ω cm were formed by low voltage dc magnetron sputtering (LVMS) and highly dense plasma-assisted electron beam (EB) evaporation using the arc plasma generator (HDPE). The structural properties of these films were investigated using x-ray diffraction, scanning electron microscope, and electron spectroscopy for chemical analysis, in comparison with the films formed by conventional magnetron sputtering and EB evaporation, in order to clarify the key factors for low resistivity. With decreasing plasma impedance and sputtering voltages from 540 to 380 V, the resistivity of the films deposited at Ts=400 °C decreased from 1.92 to 1.34×10−4 Ω cm, due mostly to increase in the carrier density. This LVMS film showed higher crystallinity because of lower damages of high-energy particles during the deposition, which might increase the number of electrically active species. For HDPE, the film with resistance of 1.23×10−4 Ω cm was deposited at Ts=280 °C, which showed more flat surface morphology and less surface segregation of tin than the conventional EB films.
16
The identification of molecular spectra
Journal of the Franklin Institute · 1951 · 2.3K citations
S. Ishibashi, Yoshiyuki Higuchi, Yukihide Ota et al. · Journal of Vacuum Science & Technology A Vacuum Surfaces and Films · 1990 · 275 citations
Natural Sciences, Electrical Engineering, Materials Science +17