Publication | Closed Access
Reaction of atomic fluorine with silicon
72
Citations
19
References
1985
Year
Chemical EngineeringEngineeringNanotechnologyEtch RateSurface ScienceApplied PhysicsSiliceneAtomic PhysicsF AtomsSemiconductor Device FabricationVacuum DeviceChemistryAtomic FluorineGas Discharge PlasmaPlasma EtchingPlasma ProcessingSilicon On InsulatorSi Surface
The etch rate of Si with F atoms was measured by the use of F2 microwave plasma over a range of discharge pressures between 2.7×10−2 and 17 Pa. Fluorine atom concentration in the plasma was determined over the same pressure range by means of both gas-phase titration and actinometry using Ar gas. A Si surface etched at 1.0×10−1, 5.3×10−1, 1.3, and 5.3 Pa was analyzed with XPS without exposing the surface to room air. A linear relation was obtained between the Si etch rate and the F atom concentration at discharge pressures between 2.7×10−2 and 2.7 Pa. The reaction probability of F atoms with Si to yield SiF4 was determined from the linear relation to be 0.1 for a Si surface at about 300 K. When the discharge pressure was higher than 1.3 Pa, the surface became rather strongly oxidized by O atoms resulting from residual gases. This surface oxidation results in a slight saturation of the Si etch rate at about 10 Pa.
| Year | Citations | |
|---|---|---|
Page 1
Page 1