ACS Applied Materials & Interfaces · 2022 · 40 citations · 43 references
EngineeringMaterials EngineeringMaterials ScienceAdditive ManufacturingCeramic MaterialsCeramicsCeramic Additive ManufacturingCeramic ProcessingCeramic TechnologyElectroless PlatingHybrid Additive ManufacturingHybrid FabricationCeramic Production TechnologyElectrical Conductivity EnhancementFunctional Ceramic FabricationPrinted Circuit BoardsSurface Finish ImprovementSurface Roughness Optimization
With increasing interest in the rapid development of customized ceramic electronics, hybrid additive manufacturing (HAM) technology has become a competent alternative to traditional solutions such as printed circuit boards and cofired ceramic technology. Herein, the novel HAM technology is proposed by combining a dispensing three-dimensional (3D) printing process and selectively laser-activated electroless plating for fabricating 3D fully functional ceramic electronic products. An appropriative 3D-printable and metalizable low-temperature cofired ceramic slurry is developed to build the green body of ceramic electronics. After the debinding and sintering process, the 3D ceramic structure can be selectively laser-activated and then electrolessly plated to achieve electronic functionality. The thickness of the plated copper layer approaches 10 μm after 4 h of plating, and the electrical conductivity is 5.5 × 107 S m–1, which is close to pure copper (5.8 × 107 S m–1). To reduce the surface roughness of the laser-activated ceramic surface and thereby enhance the conductivity of the copper layer, the laser parameters are optimized as a 1250 mm s–1 scan speed, a 0.4 W laser power, and a 20 kHz laser-spot frequency. A high-power 3D light-emitting diode circuit board with an internal cooling channel is successfully developed to prove the feasibility of this HAM technology for customizing fully functional 3D conformal ceramic electronics.
43
Ultralight Metallic Microlattices
Tobias A. Schaedler, A. J. Jacobsen, Anna Torrents et al. · Science · 2011 · 1.7K citations
Natural Sciences, Materials Engineering, Materials Science +17
3D Printing for the Rapid Prototyping of Structural Electronics
Eric MacDonald, Rudy Salas, David Espalin et al. · IEEE Access · 2014 · 596 citations · Full text
Engineering, Manufacturing Engineering, Materials Engineering +15
Direct writing technology—Advances and developments
K.K.B. Hon, L. Li, Ian M. Hutchings · CIRP Annals · 2008 · 479 citations