Chinese Journal of Aeronautics · 2020 · 77 citations · 34 references
EngineeringMaterials EngineeringMaterials ScienceMechanical Behavior Of MaterialsMetallurgySurface EngineeringAbrasive WearCreep DeformationMachiningSurface HardeningWear-resistant MaterialsAbrasive Wear BehaviorAbrasive Wear ResistanceGrindingGrinding BehaviorMaterial Wear AnalysisSurface Defects CharacterizationSurface IntegritySurface Integrity Assessment
This paper evaluates the performance of creep feed grinding γ-TiAl intermetallic (Ti-45Al-2Mn-2Nb) using electroplated diamond wheels. Firstly, a comparative analysis with the grinding results by using electroplated CBN wheels was conducted, mainly involving abrasive wheel wear behavior and maximum material removal rate below surface burn limit. It was found that the diamond wheel would produce much better grinding results including lower wheel wear rate and higher maximum material removal rate. Then the surface integrity obtained at different level of material removal rate was characterized with the utilization of the diamond wheel. The poor ductility of this γ-TiAl intermetallic material was found to have a marginal effect on the surface integrity, as no severe surface defects such as material pullout were generated during the stable wheel wear stage. For the involved operating parameters, a deformation layer was produced with ∼10 μm or more in thickness depending on the material removal rate used. Meanwhile, a work-hardened layer extending to more than 100 μm was produced with a maximum microhardness of above 520 HV0.05 (bulk value 360 HV0.05). The residual stress remained compressive, with a value of above −100 MPa and even up to −500 MPa for an elevated material removal rate. Shearing chip was the main chip type, indicating good wheel sharpness in the grinding process.
34
Changes in surface layer of silicon wafers from diamond scratching
Zhenyu Zhang, Bo Wang, Renke Kang et al. · CIRP Annals · 2015 · 232 citations
Abrasive machining of advanced aerospace alloys and composites
Fritz Klocke, Sein Leung Soo, Bernhard Karpuschewski et al. · CIRP Annals · 2015 · 221 citations
Engineering, Aerospace Engineering, Materials Engineering +14
New Deformation-Induced Nanostructure in Silicon
Bo Wang, Zhenyu Zhang, Keke Chang et al. · Nano Letters · 2018 · 209 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +17
Wenfeng Ding, Chenwei Dai, Tianyu Yu et al. · International Journal of Machine Tools and Manufacture · 2017 · 195 citations