Dynamics analysis of a slender ball-screw feed system considering the changes of the worktable position

Huijie Zhang, Hui Liu, Chao Du, Dun Lv, Jun Zhang, Wanhua Zhao

Proceedings of the Institution of Mechanical Engineers Part C Journal of Mechanical Engineering Science · 2018 · 25 citations · 17 references

Concepts

TL;DR

In a slender ball‑screw feed system, the moving worktable causes large changes in screw‑nut joint positions, leading to variations in compression/tension and torsion stiffness that alter the system’s transmission stiffness and overall dynamics. The study develops a dynamic model and stiffness/mass calculation method for the slender ball‑screw feed system that accounts for worktable position changes using a hybrid element approach. The authors verified the model with experiments at various positions and examined how length, screw‑tension force, pitch, nominal diameter, and rated dynamic load affect the system’s natural frequency throughout the stroke. The study found that the system’s dynamics vary with position, and that keeping the length‑to‑diameter ratio below 50 yields more uniform dynamics for large machine tools.

Abstract

For a slender ball-screw feed system, the position of the screw–nut joints will change greatly when the moving worktable moves along its whole stroke. Therefore, the compression/tension and torsion stiffness of the screw-shaft on both sides of the screw–nut joints will change. Thus, the system transmission stiffness will also vary and affect its dynamics. In this article, considering the changes of the worktable position and using hybrid element method, a dynamic model was established for the slender ball-screw feed system, and a calculation method of the system stiffness and mass matrix was provided. The experiments on the slender ball-screw feed system with different positions were also performed to verify the proposed dynamic model. Finally, the influences of length, screw-tension force, pitch, nominal diameter of screw and rated dynamic load of screw-nut joints on the slender ball-screw feed system’s natural frequency along its whole stroke were studied. The results showed that the slender ball-screw feed system possesses obvious position-dependent variable dynamics along its whole stroke; the ratio of length to diameter of the screw ( L f / d 0 ) would be better designed smaller than 50 in order to obtain the relative uniformity of the system dynamics when manufacturing large machine tools.

References

17