Using a large-angle gauge to select trees for measurement in variable plot sampling

Abstract

Variable plot sampling has been widely used for many years. It was recognized, early in its application, that the process of getting stand volume could be divided into two components, counting trees to get basal area per unit area and measuring trees to get volume/basal area ratios (VBARs). It was further recognized that these two components had different amounts of variation and therefore should be sampled at different intensities. The fact that basal area per unit area is almost always more variable than the VBARs of individual trees has led to the widespread practice of counting trees on all plots and subsampling trees for VBAR measurements, typically by measuring all the trees on every third or fourth plot. This article presents an alternative, the "big BAF method," which uses a larger basal-area-factor angle gauge to do a second sweep of each plot to select the trees to be measured for VBAR. This procedure spreads the tree measurements throughout the stand and is thus more statistically efficient. The method is simple to apply, requires no additional computations, and is easy to audit. Two case-study examples are used to demonstrate the method.