Advanced Energy Materials · 2011 · 442 citations · 47 references
Natural SciencesMaterials EngineeringMaterials ScienceMaterials ChemistrySemiconductor MaterialsThin FilmsAtomic Layer DepositionMetal SulfidesPhotovoltaic MaterialsSemiconductor Thin FilmsSolar Cell MaterialsSolar CellsAnisotropic Electrical PropertiesBand GapCarrier ConcentrationDirect Band GapElectrical PropertiesMetal Sulfide Thin FilmsOptical AbsorptionOptical Band Gap
Abstract Thin film solar cells made from earth‐abundant, non‐toxic materials are needed to replace the current technology that uses Cu(In,Ga)(S,Se) 2 and CdTe, which contain scarce and toxic elements. One promising candidate absorber material is tin monosulfide (SnS). In this report, pure, stoichiometric, single‐phase SnS films were obtained by atomic layer deposition (ALD) using the reaction of bis( N , N′‐ diisopropylacetamidinato)tin(II) [Sn(MeC(N‐ i Pr) 2 ) 2 ] and hydrogen sulfide (H 2 S) at low temperatures (100 to 200 °C). The direct optical band gap of SnS is around 1.3 eV and strong optical absorption ( α > 10 4 cm −1 ) is observed throughout the visible and near‐infrared spectral regions. The films are p‐type semiconductors with carrier concentration on the order of 10 16 cm −3 and hole mobility 0.82–15.3 cm 2 V −1 s −1 in the plane of the films. The electrical properties are anisotropic, with three times higher mobility in the direction through the film, compared to the in‐plane direction.
47
The Scherrer Formula for X-Ray Particle Size Determination
A. L. Patterson · Physical Review · 1939 · 8.9K citations
Infrared and Raman spectra of the IV-VI compounds SnS and SnSe
H. R. Chandrasekhar, R.G. Humphreys, Uri Zwick et al. · Physical review. B, Solid state · 1977 · 537 citations