Influence of nonsoluble contaminants on the flashover voltages of artificially contaminated insulators

Ryosuke Matsuoka, Kenta Kondo, K. Naito, Masaru Ishii

IEEE Transactions on Power Delivery · 1996 · 64 citations · 5 references

Concepts

TL;DR

The study investigates how nonsoluble contaminants, Tonoko and Kaolin, affect flashover voltages of artificially contaminated insulators. The authors examined flashover voltages by contaminating insulators with suspensions of Tonoko or Kaolin and measuring the resulting voltages under DC and AC conditions. Kaolin deposits less densely than Tonoko yet yields higher flashover voltages under both DC and AC, a difference attributed to Tonoko’s less uniform layer; adding a dispersion agent to Tonoko improves layer uniformity and brings its flashover voltage up to Kaolin levels.

Abstract

This paper describes the results of investigation into the influence of a kind of nonsoluble contaminant (Tonoko or Kaolin) on flashover voltages of artificially contaminated insulators. The deposit density of Kaolin on the insulator surface is less than that of Tonoko when contaminated with the suspension containing the same amount of Tonoko or Kaolin. However, a discernible difference is observed in contamination flashover voltage between these two nonsoluble contaminants, not only under DC but also under AC when nonsoluble contaminant deposit densities (NSDD) are adjusted to the same degree. The difference in the performance is considered attributable to the less uniform contaminant layer produced by Tonoko suspension compared with Kaolin. When a dispersion agent was added to Tonoko suspension, which does not give any influence on the conductivity of the suspension, the layer uniformity and flashover voltage (FOV) for this modified Tonoko suspension became almost equal to those for Kaolin.

References

5