Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE · 2008 · 33 citations · 17 references
EngineeringMaterials EngineeringMaterials ScienceOptoelectronicsSemiconductor DevicesSemiconductor MaterialsCoatingsIii-v SemiconductorsPhotovoltaic DevicesSolar CellsSolar Energy SystemsSolar Photovoltaic SystemsAnti-reflection CoatingsAntireflection CoatingsIrradianceIrradiance DependenceMulti-junction Solar CellsPhotocurrent GenerationPhotovoltaic SystemsSilicon Solar Cells
Photovoltaic solar cells are a route towards local, environmentally benign, sustainable and affordable energy solutions. Antireflection coatings are necessary to input a high percentage of available light for photovoltaic conversion, and therefore have been widely exploited for silicon solar cells. Multi-junction III-V semiconductor solar cells have achieved the highest efficiencies of any photovoltaic technology, yielding up to 40% in the laboratory and 37% in commercial devices under varying levels of concentrated light. These devices benefit from a wide absorption spectrum (300- 1800 nm), but this also introduces significant challenges for antireflection coating design. Each sub-cell junction is electrically connected in series, limiting the overall device photocurrent by the lowest current-producing junction. Therefore, antireflection coating optimization must maximize the current from the limiting sub-cells at the expense of the others. Solar concentration, necessary for economical terrestrial deployment of multi-junction solar cells, introduces an angular-dependent irradiance spectrum. Antireflection coatings are optimized for both direct normal incidence in air and angular incidence in an Opel Mk-I concentrator, resulting in as little as 1-2% loss in photocurrent as compared to an ideal zero-reflectance solar cell, showing a similar performance to antireflection coatings on silicon solar cells. A transparent conductive oxide layer has also been considered to replace the metallic-grid front electrode and for inclusion as part of a multi-layer antireflection coating. Optimization of the solar cell, antireflection coating, and concentrator system should be considered simultaneously to enable overall optimal device performance.
17
40% efficient metamorphic GaInP∕GaInAs∕Ge multijunction solar cells
Richard R. King, D. C. Law, K. Edmondson et al. · Applied Physics Letters · 2007 · 1.2K citations · Full text