Development of a Solid-Phase Extraction Method for Phenoxy Acids and Bentazone in Water and Comparison to a Liquid−Liquid Extraction Method

Abstract

A rapid solid-phase extraction (SPE) method was developed for the determination of bentazone and the phenoxy acids 2,4-D, dichlorprop, MCPA, and mecoprop in Norwegian environmental water samples. Cartridges with a high-capacity cross-linked polystyrene-based polymer were used for off-line preconcentration. The effects of elution solvent, elution volume, sample volume, sorbent mass, pH, and flow rate on the recoveries of the pesticides were investigated using HPLC. Average recovery of >90% was achieved with 500 mg sorbents using 2 mL of methanol with 5% NH3 as elution solvent. The recoveries were independent of sample pH in the tested range of pH 1-7. Using a sample volume of 200 mL, the limits of determination for the phenoxy acids and bentazone are 0.02 microg/L. Sample volumes up to 2000 mL at a flow rate of 60 mL/min could be handled without any loss of analytes, which makes it possible to lower the limits of determination. The SPE method was compared to a routinely used liquid-liquid extraction method. Three different water matrices spiked at 1.0 and 0.05 microg/L were extracted, and the quantification was performed by GC-MS. Both methods permitted the determination of phenoxy acids and bentazone in distilled water, creek water, and well water down to a level of 0.05 microg/L with recoveries >80% for 200 mL samples. Important advantages of the SPE method compared to the liquid-liquid extraction method were the short extraction times, lack of emulsions, use of disposable equipment, and reduced consumption of organic solvents.