Applied Physics Letters · 1995 · 66 citations · 0 references
EngineeringMaterials EngineeringMaterials ScienceElectronic MaterialsSemiconductor MaterialsSurface ChemistryDefects In Electronic MaterialsSemiconductor DefectsSemiconductor HeterostructuresSemiconductor SurfacesSemiconductor Thin FilmsStacking FaultsEpitaxial Film GrowthFilm Growth MechanismsLayer-by-layer GrowthStacking Fault EffectsStacking Fault FormationStacking Faults In SemiconductorsStructural DefectsSubstrate Surface Preparation
A systematic dependence of the density and type of stacking fault defects with substrate surface chemistry and film growth mode was observed in ZnSe-based films grown on GaAs substrates. Namely, the density of Frank-type stacking faults is very large for films grown on Ga-rich surfaces, but is very low for films grown on As-stabilized surfaces exposed to Zn prior to the growth of the film. In contrast, the density of Shockley-type stacking faults increases for films grown by 3D growth mode at the initial stages of growth, but decreases greatly if the films are grown by the layer-by-layer growth mode. Films with stacking fault densities as low as 104/cm2 were obtained by growing the films by the layer-by-layer growth on GaAs epilayers with As-stabilized surfaces that were exposed to Zn for 1–2 min prior to the growth of the films.