Journal of Applied Physics · 1999 · 1.3K citations · 33 references
Natural SciencesMaterials EngineeringMaterials ScienceElectronic MaterialsOptical MaterialsSemiconductor MaterialsOptoelectronic DevicesOptoelectronic MaterialsSemiconductor Thin FilmsThin Film Electrical PropertiesThin Film Optical PropertiesThin-film DepositionFilm ThicknessIndium Tin Oxide Thin FilmsLight-emitting DevicesOptical PropertiesPulsed Laser DepositionSubstrate Temperature EffectsThin Oxide FilmsTin Oxides
High-quality indium–tin–oxide (ITO) thin films (200–850 nm) have been grown by pulsed laser deposition (PLD) on glass substrates without a postdeposition annealing treatment. The structural, electrical, and optical properties of these films have been investigated as a function of target composition, substrate deposition temperature, background gas pressure, and film thickness. Films were deposited from various target compositions ranging from 0 to 15 wt % of SnO2 content. The optimum target composition for high conductivity was 5 wt % SnO2+95 wt % In2O3. Films were deposited at substrate temperatures ranging from room temperature to 300 °C in O2 partial pressures ranging from 1 to 100 mTorr. Films were deposited using a KrF excimer laser (248 nm, 30 ns full width at half maximum) at a fluence of 2 J/cm2. For a 150-nm-thick ITO film grown at room temperature in an oxygen pressure of 10 mTorr, the resistivity was 4×10−4 Ω cm and the average transmission in the visible range (400–700 nm) was 85%. For a 170-nm-thick ITO film deposited at 300 °C in 10 mTorr of oxygen, the resistivity was 2×10−4 Ω cm and the average transmission in the visible range was 92%. The Hall mobility and carrier density for a 150-nm-thick film deposited at 300 °C were 27 cm2/V s and 1.4×1021 cm−3, respectively. A reduction in the refractive index for ITO films can be achieved by raising the electron density in the films, which can be obtained by increasing the concentration of Sn dopants in the targets and/or increasing deposition temperature. Atomic force microscopy measurements of these ITO films indicated that their root-mean-square surface roughness (∼5 Å) was superior to that of commercially available sputter deposited ITO films (∼40 Å). The PLD ITO films were used to fabricate organic light-emitting diodes. From these structures the electroluminescence was measured and an external quantum efficiency of 1.5% was calculated.
33
Organic electroluminescent diodes
Chak Wah Tang, S. A. VanSlyke · Applied Physics Letters · 1987 · 14.3K citations
Natural Sciences, Materials Engineering, Materials Science +17
Optical Properties and Electronic Structure of Amorphous Germanium
J. Tauc, R. Grigorovici, A. Vancu · physica status solidi (b) · 1966 · 10.7K citations
Anomalous Optical Absorption Limit in InSb
Elias Burstein · Physical Review · 1954 · 3.9K citations
Natural Sciences, Physics, Optics +10
New figure of merit for transparent conductors
G. Haacke · Journal of Applied Physics · 1976 · 2.1K citations
Natural Sciences, Materials Engineering, Materials Science +17