Journal of Vacuum Science & Technology A Vacuum Surfaces and Films · 2008 · 70 citations · 48 references
Natural SciencesMaterials EngineeringMaterials ScienceMaterials CharacterizationSemiconductor MaterialsThin FilmsDislocations In SemiconductorsEpitaxial GrowthMetal OxidesOxide SemiconductorsSemiconductor Crystal GrowthSemiconductor Device MaterialsDislocation DensityDislocations In Epitaxial FilmsEpitaxial Film GrowthMolecular Beam EpitaxySemiconductor Oxide Thin FilmsThin Oxide FilmsTin OxidesVolmer-weber Growth
Plasma-assisted molecular beam epitaxy has been shown to be a viable and practical method for producing high quality tin oxide, SnO2. Phase-pure epitaxial single crystalline SnO2 (101) thin films of 1μm in thickness were reproducibly grown on r-plane sapphire Al2O3 (101¯2) substrates. The SnO2 epitaxy progressed in the Volmer–Weber growth mode. A minimum on-axis ω-scan full width at half maximum of 0.22° for the SnO2 (101) peak was measured indicating relatively low film mosaic. An epitaxial relationship of [010]SnO2∥[1¯21¯0]sapphire and [1¯01]SnO2∥[1¯011]sapphire was determined between the film and substrate. A SnO2 film tilt of 1.3° around the [010]SnO2 toward [0001]sapphire was measured. A dislocation density of 8×109cm−2 was measured. Hall effect measurements quantified an unintentionally doped electron concentration for different samples in a range (0.3–3.0)×1017cm−3 with a corresponding electron mobility range of 20–100cm2∕Vs. The SnO2 growth behavior was determined to be in one of the two distinct growth regimes. An oxygen-rich regime was characterized by a linear increase in the film growth rate with increasing Sn flux; whereas, the films grown entirely in the Sn-rich regime showed a decrease in the growth rate with increased Sn flux.
48
Synthesis and luminescence properties of SnO2 nanoparticles
Feng Gu, Shu Wang, Chun Song et al. · Chemical Physics Letters · 2003 · 404 citations
Natural Sciences, Materials Engineering, Materials Science +14