Modeling of surface cleaning by cavitation bubble dynamics and collapse

TLDR

Cleaning effectiveness depends on bubble size relative to particle size, standoff distance, and excitation pressure. The study numerically investigates surface cleaning by cavitation bubble dynamics, modeling bubble behavior, particle motion, and fluid–material interaction, and discusses the influencing effects. The authors employ three fluid dynamics models (potential flow, viscous, compressible) to describe the bubble‑generated flow and a finite element structure code to simulate fluid–structure interaction and material failure. Bubble deformation, reentrant jet formation, and explosive growth generate concentrated pressures, shear, lift, and suction forces that lift dirt particles and produce high impulsive loads on material surfaces, leading to pits and material removal when stresses exceed yield.

Abstract

Surface cleaning using cavitation bubble dynamics is investigated numerically through modeling of bubble dynamics, dirt particle motion, and fluid material interaction. Three fluid dynamics models; a potential flow model, a viscous model, and a compressible model, are used to describe the flow field generated by the bubble all showing the strong effects bubble explosive growth and collapse have on a dirt particle and on a layer of material to remove. Bubble deformation and reentrant jet formation are seen to be responsible for generating concentrated pressures, shear, and lift forces on the dirt particle and high impulsive loads on a layer of material to remove. Bubble explosive growth is also an important mechanism for removal of dirt particles, since strong suction forces in addition to shear are generated around the explosively growing bubble and can exert strong forces lifting the particles from the surface to clean and sucking them toward the bubble. To model material failure and removal, a finite element structure code is used and enables simulation of full fluid-structure interaction and investigation of the effects of various parameters. High impulsive pressures are generated during bubble collapse due to the impact of the bubble reentrant jet on the material surface and the subsequent collapse of the resulting toroidal bubble. Pits and material removal develop on the material surface when the impulsive pressure is large enough to result in high equivalent stresses exceeding the material yield stress or its ultimate strain. Cleaning depends on parameters such as the relative size between the bubble at its maximum volume and the particle size, the bubble standoff distance from the particle and from the material wall, and the excitation pressure field driving the bubble dynamics. These effects are discussed in this contribution.