Journal of the aeronautical sciences. [REQUEST TITLE] · 1950 · 19 citations · 2 references
EngineeringAerospace EngineeringMechanical EngineeringAerodynamicsFluid DynamicsHeat TransferAirfoil TheoryComputational AerodynamicsHeat Transfer ModelingSupersonic AerodynamicsThermal Boundary LayersTransient Heat TransferAirfoil AerodynamicsHeat Transfer MechanismsMach NumberOne-dimensional Heat TransferSupersonic AirfoilsTemperature Rise AnalysisTransient Temperature ModelingTransient Thermal Stresses
The motion of a vehicle a t high supersonic speeds results in a large nonuniform temperature rise within the vehicle. Several new problems, such as the magnitudes of the thermal stresses and of the aerodynamic deflections caused by this nonuniform temperature distribution, must be solved by the designer. These problems depend, in turn, on accurate prediction of this transient temperature distribution. The calculation of the transient temperature distribution is illustrated for the case of a thin wedge-shaped wing or airfoil subjected to constant acceleration from Mach Numbers of 1.4 to 6. The calculation depends strongly on the state of the ar t relative to heat transfer at supersonic speeds; as a result, the calculations may be systematically in error because of the lack of data in this art. A long and laborious numerical method of solution of the differential equation for heat flow in two dimensions with boundary conditions dependent on time is presented, and the resultant temperature distributions in the wing are given in chart form. In this solution the spanwise heat flow is assumed to be negligible. The results indicated that the heat-flow problem could be reduced to one-dimensional heat flow in the direction normal to the chord without sacrifice of accuracy for a wing with a maximum thickness ratio of less than 10 per cent. A shorter numerical method of solution of the differential equation for heat flow in one dimension—normal to the chord—is presented. I t is shown that this method yields temperature distributions that are in excellent agreement with those calculated by the method for two-dimensional heat flow. This shorter method was used to investigate the effects of changes in the coefficients of heat transfer and in the values of the acceleration. I t is shown that this shorter numerical method of solution is applicable to the general case of a thin airfoil, provided the variation of the local coefficient of heat transfer with time is available.
2