1e:T470,A highly sensitive light-induced thermoelectric spectroscopy (LITES) sensor based on a multi-pass cell (MPC) with dense spot pattern and a novel quartz tuning fork (QTF) with low resonance frequency is reported in this manuscript. An erbium-doped fiber amplifier (EDFA) was employed to amplify the output optical power so that the signal level was further enhanced. The optical path length (OPL) and the ratio of optical path length to volume (RLV) of the MPC is 37.7 m and 13.8 cm^-2, respectively. A commercial QTF and a self-designed trapezoidal-tip QTF with low frequency of 9461.83 Hz were used as the detectors of the sensor, respectively. The target gas selected to test the performance of the system was acetylene (C₂H₂). When the optical power was constant at 1000 mW, the minimum detection limit (MDL) of the C₂H₂-LITES sensor can be achieved 48.3 ppb when using the commercial QTF and 24.6 ppb when using the trapezoidal-tip QTF. An improvement of the detection performance by a factor of 1.96 was achieved after replacing the commercial QTF with the trapezoidal-tip QTF.1f:T4e2,Photoacoustic spectroscopy (PAS) as a highly sensitive and selective trace gas detection technique has extremely broad application in many fields. However, the laser sources currently used in PAS limit the sensing performance. Compared to diode laser and quantum cascade laser, the solid-state laser has the merits of high optical power, excellent beam quality, and wide tuning range. Here we present a long-wave, high-power, wide-tunable, single-longitudinal-mode solid-state laser used as light source in a PAS sensor for trace gas detection. The self-built solid-state laser had an emission wavelength of ~2 μm with Tm:YAP crystal as the gain material, with an excellent wavelength and optical power stability as well as a high beam quality. The wide wavelength tuning range of 9.44 nm covers the absorption spectra of water and ammonia, with a maximum optical power of ~130 mW, allowing dual gas detection with a single laser source. The solid-state laser was used as light source in three different photoacoustic detection techniques: standard PAS with microphone, and external- and intra-cavity quartz-enhanced photoacoustic spectroscopy (QEPAS), proving that solid-state laser is an attractive excitation source in photoacoustic spectroscopy.20:T58b,

	Year	Citations

References