Machinability of extruded H13 tool steel: Effect of cutting parameters on cutting forces, surface roughness, microstructure, and residual stresses

Abstract

The production of H13 tool steel (TS) by material extrusion (MEX) is a promising method in various applications, but as-built surface roughness does not comply with the quality requirements. Hence, this study investigated the effects of cutting parameters on tool wear, cutting forces, surface quality, microhardness, structure, and residual stresses when machining H13 TS produced by MEX. Dry machining (DM) proved advantageous in certain indicators such as tool wear and cutting forces in comparison to the flood cooling (FC). The lowest surface roughness (0.08 µm) was achieved at the cutting speed of 80 m/min, feed per tooth of 0.005 mm, and FC which corresponded to a 41 % decrease compared to DM under same conditions. Surface microhardness increased by 20 % after machining, decreasing with distance from the surface. The highest compressive residual stresses were observed under FC, while the DM resulted in a 78.2 % decrease in residual stresses due to a partial annealing effect caused by higher surface temperature. Overall, DM exhibited great potential for achieving high-quality surfaces with a favorable structure and residual stresses. This study´s novelty and robustness lie in its significant contribution to practical industrial applications, such as mold and core production.