Experimental investigation of the influence of wire offset and composition on complex profile WEDM of Ti6Al4V using trim-pass strategy

Electrical discharge machining of titanium alloy (Ti–6Al–4V)

Ahmet Hasçalık, Ulaş Çaydaş · Applied Surface Science · 2007 · 460 citations

Engineering, Manufacturing Engineering, Materials Engineering +14

Workpiece surface roughness and integrity after WEDM of Ti–6Al–4V and Inconel 718 using minimum damage generator technology

D.K. Aspinwall, Sein Leung Soo, A.E. Berrisford et al. · CIRP Annals · 2008 · 253 citations

Engineering, Manufacturing Engineering, Materials Science +13

Optimization of the EDM parameters on machining Ti–6Al–4V with multiple quality characteristics

J. Y. Kao, C.C. Tsao, S. S. Wang et al. · The International Journal of Advanced Manufacturing Technology · 2009 · 227 citations

Engineering, Manufacturing Engineering, Materials Engineering +12

Modeling and optimization of wire electrical discharge machining of γ-TiAl in trim cutting operation

Soham Sarkar, Mukandar Sekh, S. Mitra et al. · Journal of Materials Processing Technology · 2007 · 147 citations

Engineering, Electrical Engineering, Manufacturing Engineering +10

Evaluation of Advanced Wire-EDM Capabilities for the Manufacture of Fir Tree Slots in Inconel 718

Fritz Klocke, D. Welling, A. Klink et al. · Procedia CIRP · 2014 · 108 citations · Full text

Engineering, Manufacturing Engineering, Materials Engineering +15