Journal of Manufacturing Processes · 2020 · 37 citations · 23 references
EngineeringManufacturing EngineeringMaterials EngineeringMechanical Behavior Of MaterialsMetallurgySurface Engineering3D PrintingAlloysMicrostructure AnalysisSurface RoughnessContouringContouring StrategiesElectron Beam MeltingPorosityShrinkageSubsurface Damage ReductionTensile StrengthVoids
This work systematically analyzes the influence of rough surfaces and porous subsurfaces in electron beam melting (EBM) printed components. Consequently, it applies various contouring strategies to improve the tensile properties of EBM printed Inconel 625 alloy parts. It is shown that no contouring (i.e., only hatching) creates a rough surface with numerous surface voids (as translated to surface notches). Although the commercially used multi-spot contouring can smoothen the surface to some extent (∼34 %), it fails to create a defect-free superficial region by leaving ∼25 % surface voids (translated to large surface notches) and ∼4 % subsurface porosity. These superficial defects form due to an interrupted shrinkage, occurring on the surface and in the contouring region. In contrast, optimal post-hatching high energy continuous contouring creates a thick and consistent post-hatching track that can successfully reconsolidate surface voids remaining from the hatching step. In comparison with the multi-spot contouring, this reduces the surface and subsurface porosity down to ∼10 % and ∼0.4 %, respectively, and hence increases the apparent stiffness by ∼140 %, tensile strength by ∼105 % and elongation by ∼260 %. This nearly reaches the mechanical properties of the conventionally machined parts (UTS ∼635 ± 20 MPa and elongation ∼50 ± 2 %).
23
NIH Image to ImageJ: 25 years of image analysis
Caroline A Schneider, Wayne Rasband, Kevin W. Eliceiri · Nature Methods · 2012 · 65.2K citations
Materials for additive manufacturing
David L. Bourell, Jean Pierre Kruth, Ming C. Leu et al. · CIRP Annals · 2017 · 1K citations