Evaluation of turning with different cooling-lubricating techniques in terms of surface integrity and tribologic properties

Radosław W. Maruda, Grzegorz Królczyk, Szymon Wojciechowski, Natalia Szczotkarz, Marcin Matuszak, Navneet Khanna

Tribology International · 2020 · 124 citations · 48 references

DOIFull text

Open access

Concepts

TL;DR

The study evaluates the metrological and tribological characteristics of surfaces produced by turning using different cooling/lubricating strategies. Machining trials compared dry, minimum‑quantity cooling lubrication (MQCL), MQCL with phosphate‑ester EP/AW additives (MQCL+EP/AW), and minimum‑quantity lubrication (MQL), with surface topography measured to assess tribological performance. Results show that MQCL+EP/AW yields the lowest surface roughness, whereas MQL provides the highest oil‑retention parameters on the machined surfaces.

Abstract

This research presents the analysis of metrologic and tribologic aspects of machined surfaces obtained after turning with the application of various cooling/lubricating methods. The thoroughly conducted machining tests are: dry machining, minimum quantity cooling lubrication (MQCL); minimum quantity cooling lubrication with EP/AW modifications (MQCL+EP/AW) and minimum quantity lubrication (MQL). The phosphate ester based modification in the MQCL+EP/AW method is employed in order to increase the lubricating properties of the emulsion. The surface topography, responsible for the tribological properties of mating parts, is measured. The smallest values of the surface roughness are obtained after turning under MQCL+EP/AW conditions, while the highest values of parameters responsible for oil retention in mating parts are obtained after machining with the MQL method.

References

48