NPG Asia Materials · 2019 · 99 citations · 62 references
EngineeringMaterials EngineeringMaterials ScienceSemiconductor DevicesSemiconductor MaterialsThin FilmsFerroelectric MaterialsPhotovoltaic DevicesSemiconductor Device MaterialsSemiconductor Thin FilmsSolar CellsThin-film MaterialsFerroelectric Thin FilmsFilm ThicknessFilm Thickness ControlLight AbsorptionSchottky Barrier CharacteristicsSchottky BarriersSeries ResistanceThin-film Solar Cells
Abstract Achieving high power conversion efficiencies (PCEs) in ferroelectric photovoltaics (PVs) is a longstanding challenge. Although recently ferroelectric thick films, composite films, and bulk crystals have all been demonstrated to exhibit PCEs >1%, these systems still suffer from severe recombination because of the fundamentally low conductivities of ferroelectrics. Further improvement of PCEs may therefore rely on thickness reduction if the reduced recombination could overcompensate for the loss in light absorption. Here, a PCE of up to 2.49% (under 365-nm ultraviolet illumination) was demonstrated in a 12-nm Pb(Zr 0.2 Ti 0.8 )O 3 (PZT) ultrathin film. The strategy to realize such a high PCE consists of reducing the film thickness to be comparable with the depletion width, which can simultaneously suppress recombination and lower the series resistance. The basis of our strategy lies in the fact that the PV effect originates from the interfacial Schottky barriers, which is revealed by measuring and modeling the thickness-dependent PV characteristics. In addition, the Schottky barrier parameters (particularly the depletion width) are evaluated by investigating the thickness-dependent ferroelectric, dielectric and conduction properties. Our study therefore provides an effective strategy to obtain high-efficiency ferroelectric PVs and demonstrates the great potential of ferroelectrics for use in ultrathin-film PV devices.
62
Switchable Ferroelectric Diode and Photovoltaic Effect in BiFeO <sub>3</sub>
Taekjib Choi, S. Lee, Young Jai Choi et al. · Science · 2009 · 2K citations
Natural Sciences, Electrical Engineering, Materials Science +15
Above-bandgap voltages from ferroelectric photovoltaic devices
So‐Young Yang, Jan Seidel, Steven J. Byrnes et al. · Nature Nanotechnology · 2010 · 1.8K citations · Full text
Natural Sciences, Materials Engineering, Materials Science +12
Perovskite oxides for visible-light-absorbing ferroelectric and photovoltaic materials
Ilya Grinberg, D. V. West, M. B. Torres et al. · Nature · 2013 · 1.4K citations
Natural Sciences, Materials Engineering, Materials Science +16
Bandgap tuning of multiferroic oxide solar cells
Riad Nechache, Cătălin Harnagea, Shun Li et al. · Nature Photonics · 2014 · 783 citations
Natural Sciences, Materials Engineering, Materials Science +14