IEEE Transactions on Power Electronics · 2019 · 17 citations · 25 references
EngineeringElectrical EngineeringEnergy SystemsPower ElectronicsRenewable Energy SystemsAc-dc ConversionAc-dc ConvertersConverter TopologiesDc-dc ConversionDc-dc ConvertersPower Factor CorrectionAc-dc RectifiersBoost Ac-dc ConvertersIsolated Ac-dc ConvertersIsolated Dc-dc ConverterLlc Resonant ConvertersOutput Voltage RegulationThree-phase PowerVoltage
A new, three-phase, single-stage, isolated ac-dc converter (rectifier) that employs only two switches and achieves less than 5% total harmonic distortion of the three-phase input currents and provides a tightly regulated, isolated, output voltage is introduced. The rectifier features zero-voltage-switching of both switches over the entire input and load range without any additional soft-switching circuitry. The rectifier is derived by combining the three-phase, power-factor-correction, discontinuous-current-mode boost rectifier that is also known as Taipei rectifier with the conventional LLC resonant half-bridge converter. The introduced rectifier requires single feedback loop with frequency control to regulate the output voltage. The evaluation was performed on a 1-kW prototype operating with a three-phase line-voltage range from 180 to 264 V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">L-L</sub> and delivering a tightly-regulated, isolated, output voltage of 54 V. The measured efficiency of the prototype at nominal line voltage V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">IN</sub> = 208 V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">L-L</sub> is above 95% from 90% of full load down to 50% of full load. The maximum voltage stress is approximately 430 V.
25
Optimal Design Methodlogy for LLC Resonant Converter
Bing Lu, W. Liu, Yan Liang et al. · 2006 · 612 citations
Engineering, Electrical Engineering, Design Optimization +14