IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control · 2018 · 31 citations · 37 references
EngineeringElectrical EngineeringMicroelectronicsMicrowave EngineeringVlsi DesignIntegrated Circuit DesignMems DesignMicrowave FiltersMicrowave Integrated CircuitsRadio-frequency Integrated CircuitsRf MemsArray DesignFilter DesignFrequency TuningInsertion LossInsertion Loss ReductionMems FiltersPassband DesignStopband Design
This Part I of two papers introduces a design flow for micromechanical RF channel-select filters with tiny fractional bandwidths capable of eliminating strong adjacent channel blockers directly after the antenna, hence reducing the dynamic range requirement of subsequent stages in an RF front-end. Much like VLSI transistor circuit design, the mechanical circuit design flow described herein is hierarchical with a design stack built upon vibrating micromechanical disk building blocks capable of Q 's exceeding 10 000 that enable low-filter passband loss for tiny fractional bandwidths. Array composites of half-wavelength coupled identical vibrating disks constitute a second level of hierarchy that reduces the filter termination impedance. A next level of hierarchy couples array composites with full-wavelength beams to affect fully balanced differential operation. Finally, identical differential blocks coupled with quarter-wavelength beams generate the desired passband. Part II of this study corroborates the efficacy of this design hierarchy via experimental results that introduce a 39-nm-gap capacitive transducer, voltage-controlled frequency tuning, and differential operation toward demonstration of a 0.1% bandwidth, 223.4-MHz channel-select filter with only 2.7 dB of in-band insertion loss and 50 dB of stopband rejection.
37
Journal of the Franklin Institute · 1963 · 5.8K citations
H.C. Nathanson, W.E. Newell, R.A. Wickstrom et al. · IEEE Transactions on Electron Devices · 1967 · 1.1K citations