Challenges and Opportunities for UAV-Based Digital Elevation Model Generation for Flood-Risk Management: A Case of Princeville, North Carolina

Leila Hashemi-Beni, Jeffery Jones, Gary L. Thompson, C. Johnson, Asmamaw Gebrehiwot

Sensors · 2018 · 98 citations · 31 references

DOIFull text

Open access

Concepts

TL;DR

Floods are the most devastating natural disaster, causing about 30 % of total disaster losses, and accurate flood‑risk mapping—dependent on high‑quality digital elevation models—is essential for prediction, planning, and damage assessment. This study investigates the quality of a UAV‑based DEM for spatial flood assessment and for evaluating the extent of the Princeville, North Carolina flood during Hurricane Matthew. The authors assessed UAV‑derived DEM accuracy by comparing its extracted water surface with USGS stream gauge and LiDAR data collected during the event. The study highlighted challenges in producing on‑demand DEMs during flooding events.

Abstract

Among the different types of natural disasters, floods are the most devastating, widespread, and frequent. Floods account for approximately 30% of the total loss caused by natural disasters. Accurate flood-risk mapping is critical in reducing such damages by correctly predicting the extent of a flood when coupled with rain and stage gage data, supporting emergency-response planning, developing land use plans and regulations with regard to the construction of structures and infrastructures, and providing damage assessment in both spatial and temporal measurements. The reliability and accuracy of such flood assessment maps is dependent on the quality of the digital elevation model (DEM) in flood conditions. This study investigates the quality of an Unmanned Aerial Vehicle (UAV)-based DEM for spatial flood assessment mapping and evaluating the extent of a flood event in Princeville, North Carolina during Hurricane Matthew. The challenges and problems of on-demand DEM production during a flooding event were discussed. An accuracy analysis was performed by comparing the water surface extracted from the UAV-derived DEM with the water surface/stage obtained using the nearby US Geologic Survey (USGS) stream gauge station and LiDAR data.

References

31