Design and Fabrication of Lever Operated Solar Lawn Mower and Contact Stress Analysis of Spur Gears

D. Satwik, N.R. Rao, M. Tech Student

2015 · 10 citations · 3 references

Concepts

Abstract

One of the main issue in a traditional lawn mower is the height of the grass cut cannot be adjusted spontaneously because the height adjustment of the rotor blade is done by lifting the whole deck with the help of wheel support and this mechanism takes time at least (4-5 minutes) to adjust the rotor. The present proposed lawn mower has a spur gear displacement mechanism in which rotor blade height can be adjusted by using the lever attached to it and that can proportionally changes the height of the grass cut of the lawn and required grass cut can be achieved and this process of adjustment will be completed in less than 20 seconds. Arduino board is used to control the speed of the motor manually and sensor is also placed in front of the machine, Corresponding required program is to be written and dumped into board. Ultrasonic sensor provides the signal to the board before the time of collision (below 30cm from the obstacle). Buzzer receives a signal from the board and produces alarm that prevents the collision. The fabrication of the proposed assembly of machine is to be done and the design of the machine is done by using design software CATIAV5. Spur gears transmit the power between motor and the rotor. Contact stresses acting on the teeth of their respective spur gears are calculated theoretically using Hertz and AGMA equation. ANSYS is used to perform static structural analysis between the spur gears and contact stresses are obtained.

References

3