2014 · 14 citations · 7 references
EngineeringBiomedical EngineeringComputer EngineeringAnalog ElectronicsLow-power DesignSensorsCardiovascular MonitoringElectrocardiographyEnergy-efficient Embedded SystemsLow-power Digital Circuit DesignPower ManagementWearable Health TechnologiesCardiac Monitoring SystemsFlip-flop ArchitectureFlip-flop DesignHeart Rate MonitoringNoise ToleranceNon-volatile MemoryWearable Health MonitoringWearable Vital Signs Sensors
This paper describes an electrocardiograph (ECG) monitoring SoC using a non-volatile MCU (NVMCU) and a noise tolerant instantaneous heart rate (IHR) monitor. The novelty of this work is the combination of the non-volatile MCU for normally-off computing and a noise-tolerant-QRS (heart beat) detection algorithm to achieve both low-power and noise tolerance. To minimize the stand-by current of MCU, a non-volatile flip-flop and a 6T-4C NVRAM are employed. Proposed plate-line charge-share and bit-line non-precharge techniques also contribute to mitigate the active power overhead of 6T-4C NVRAM. The proposed accurate heart beat detector employs a coarse-fine autocorrelation and a template matching technique. Accurate heart beat detection also contributes system level power reduction because the active ratio of ADC and digital block can be reduced using a heart beat prediction. Then, at least 25% active time can be reduced. Measurement results show the fully integrated ECG-SoC consumes 6.14µA including 1.28-µA nonvolatile MCU and 0.7-µA heart rate extractor.
7
Sun‐Young Kim, Long Yan, Srinjoy Mitra et al. · 2013 · 31 citations
Engineering, Biomedical Engineering, Electrical Engineering +17
A micropower biomedical signal processor for mobile healthcare applications
Shu-Yu Hsu, Yao-Lin Chen, Po-Yao Chang et al. · 2011 · 19 citations
Engineering, Biomedical Engineering, Computer Engineering +17