Scientific Reports · 2016 · 49 citations · 23 references
Natural SciencesMaterials EngineeringMaterials ScienceMaterials CharacterizationMetallic MaterialsMetallurgyAlloysMetal MaterialsMetalsPhase AnalysisPhysical MetallurgyStrengthening MechanismsCopper AlloysElectron Energy LossElectron Energy-loss SpectroscopyEnergy Dispersive X-ray SpectroscopyEnergy-dispersive X-ray SpectroscopyMagnesium AlloysMetallurgical CharacterizationPrecipitate Analysis
A previously undescribed high aspect ratio strengthening platelet phase, herein named the Y-phase, has been identified in a commercial Al-Zn-Mg-Cu alloy. Differential scanning calorimetry indicates that this phase only precipitates at temperature and cooling rate of about 150-250 °C and 0.05-300 K/s, respectively. This precipitate is shown to be responsible for a noticeable improvement in mechanical properties. Aberration corrected scanning transmission electron microscopy demonstrates the minimal thickness (~1.4 nm) precipitate plates are isostructural to those of the T1 (Al2CuLi) phase observed in Al-Cu-Li alloys. Low voltage chemical analysis by energy dispersive X-ray spectroscopy and electron energy loss spectroscopy gives evidence of the spatial partitioning of the Al, Cu and Zn within the Y-phase, as well as demonstrating the incorporation of a small amount of Mg.
23
Microstructural evolution during ageing of Al–Cu–Li–x alloys
Vicente Araullo‐Peters, Baptiste Gault, Frédéric De Geuser et al. · Acta Materialia · 2014 · 262 citations · Full text
Natural Sciences, Materials Engineering, Materials Science +12