Experimental Heat Transfer · 2015 · 11 citations · 15 references
EngineeringMechanical EngineeringComputational Fluid DynamicsComputational Heat TransferHeat TransferHeat ExchangeHeat ExchangersHeat FlowHeat Transfer AnalysisHeat Transfer In FluidsHeat Transfer ModelingFriction FactorHeat Exchanger ModelingHeat Exchanger PerformanceHeat Exchanger Performance AnalysisHeat Transfer MechanismsNumerical ModellingPressure DropTurbulent Flow Heat Transfer
This article experimentally and numerically analyzes the effect of turbulators with different geometries (Type I, Type II, Type III, and Type IV) located at the inlet of the inner pipe in a concentric-type heat exchanger. Experiments were performed at parallel-flow conditions in the same and opposite directions to investigate the impact of manufactured turbulators on heat transfer and pressure drop. In the numerical study, ANSYS 12.0 Fluent code program was used, and basic protection equations were solved in the steady-state, three-dimensional, and turbulence-flow conditions. Results were obtained from numerical analysis conducted at different flow values of air (7, 8, 9, 10, 11, and 12 m3/h). The distribution of temperature, velocity, and pressure was demonstrated as a result of numerical analyses. Experimental and numerical results were compared, and it was observed that they were in conformity with each other. When the data obtained from the analyses were examined, the highest heat transfer, pressure drop, and friction factor increase were detected to be in the Type IV turbulator.
15
Smith Eiamsa‐ard, Somsak Pethkool, Chinaruk Thianpong et al. · International Communications in Heat and Mass Transfer · 2007 · 160 citations