Heat Transfer from a Single Bubble Nucleation Site During Saturated Pool Boiling of FC-72 Using an Array of 100 Micron Heaters

Fatih Demiray, Jungho Kim

8th AIAA/ASME Joint Thermophysics and Heat Transfer Conference · 2002 · 12 citations · 8 references

Concepts

Abstract

Boiling heat transfer has been used in the thermal control of compact devices since the discovery of high heat transfer coefficients associated with boiling phenomena. The objective of the current work is to investigate and determine boiling heat transfer mechanisms in single and multiple bubble modes with a constant surface temperature boundary condition. The heat transfer data contained in this paper is unique because it is acquired at many locations simultaneously using a microscale heater array instead of at a single point underneath the bubbles, which yields a more detailed picture of the heat transfer process. Images of the growing bubbles were captured from below and from the side using two high-speed digital video cameras, allowing bubble behavior to be correlated with the heat transfer measurements. The data indicated that the area influenced by the bubble departure was approximately half the departure diameter. Microlayer evaporation was observed to contribute a significant, but not dominant, fraction of the wall heat transfer in the single bubble mode. Microlayer evaporation was insignificant in the multiple bubble mode, and heat transfer occurred mainly through transient conduction/microconvection during liquid rewetting as the bubble departs the surface. *

References

8