2006 · 33 citations · 6 references
MedicineBioengineeringBiomedical EngineeringDiagnostic ImagingUltrasonographyUltrasoundDiagnostic UltrasonographyMedical Imaging InstrumentationTransducer TechnologyUltrasonicsUltrasound ImagingUltrasound InstrumentationCapacitive Micromachined Ultrasonic TransducersFlip-chip BondingMedical TransducersPiezoelectric TransducersTransducer FabricationTransducersUltrasonic Transducer ArraysUltrasonic Transducers
Abstract — Real-time catheter-based ultrasound imaging tools are needed for diagnosis and image-guided procedures. The continued development of these tools is partially limited by the difficulty of fabricating two-dimensional array geometries of piezoelectric transducers. Using capacitive micromachined ultrasonic transducer (CMUT) technology, transducer arrays with widely varying geometries, high frequencies, and wide bandwidths can be fabricated. A volumetric ultrasound imaging system based on a two-dimensional, 16×16-element, CMUT array is presented. Transducer arrays with operating frequencies ranging from 3 MHz to 7.5 MHz were fabricated for this system. The transducer array including DC bias pads measures 4 mm by 4.7 mm. The transducer elements are connected to flip-chip bond pads on the array back side with 400-µm long through-wafer interconnects. The array is flip-chip bonded to a custom-designed integrated circuit (IC) that comprises the front-end electronics. Integrating the front-end electronics with the transducer array reduces the effects of cable capacitance on the transducer’s performance and provides a compact means of connecting to the transducer elements. The front-end IC provides a 27-V pulser and 10-MHz bandwidth amplifier for each element of the array. An FPGA-based data acquisition system is used for control and data acquisition. Output pressure of 230 kPa was measured for the integrated device. A receive sensitivity of 125 mV/kPa was measured at the output of the amplifier. Amplifier output noise at 5 Mhz is 112 nV/√Hz. Volumetric images of a wire phantom and vessel phantom are presented. Volumetric data for a wire phantom was acquired in real-time at 30 frames per second. Keywords-ultrasound imaging, catheter, capacitive micromachined ultrasonic transducer, CMUT, integrated electronics, volumetric, real-time I.
6
Photoacoustic imaging using a two-dimensional CMUT array
I.O. Wygant, Xuefeng Zhuang, Pao-kuang Kuo et al. · 2006 · 21 citations
High-resolution imaging with high-frequency 1-D linear CMUT arrays
David T. Yeh, Ömer Oralkan, I.O. Wygant et al. · 2006 · 18 citations