Physical Chemistry Chemical Physics · 2011 · 44 citations · 40 references
Natural SciencesMaterials EngineeringMaterials ScienceElectrochemistryMaterials ChemistryThin FilmsMetal SulfidesMetalsPhotoelectrochemical MaterialsSemiconductor SurfacesSolar Cell MaterialsSolar CellsAdherenceMetallic Thin FilmsPhotoelectrochemical CellsPinholesPrecursor ChemistryProcess AdherenceSolar Cell CharacterizationSolar Cell Fabrication
Polycrystalline CuInS(2) films were fabricated by sulfurization of electrodeposited Cu and In metallic precursor films in a Cu-rich composition at 520 °C in H(2)S (5% in Ar). Structural analyses revealed that the adherence of the thus-formed CuInS(2) film to the Mo substrate was strongly dependent on heating profiles of the Cu/In bilayer film: a CuInS(2) film with poor adherence having many crevices was formed when the Cu/In bilayer film was heated monotonously from room temperature to 520 °C in Ar within 25 min followed by sulfurization, whereas CuInS(2) films with good adherence were obtained when the Cu/In films were pretreated at 110 °C in Ar for 10-60 min just before increasing the temperature up to 520 °C for sulfurization. It was also clarified that the CuInS(2) film obtained without 110 °C pretreatment had pinholes inside the film, whereas the CuInS(2) films formed after 110 °C pretreatment showed no notable pinholes. Photoelectrochemical responses of these CuInS(2) films in an electrolyte solution containing Eu(III) indicated that the CuInS(2) films obtained after 110 °C pretreatment had higher external quantum efficiency (EQE) values than those of films obtained without 110 °C pretreatment, mainly due to better adherence of 110 °C pretreated CuInS(2) films to the Mo substrate than the CuInS(2) film obtained without 110 °C pretreatment. The performance of solar cells with an Al:ZnO/Zn(S,O)/CdS/CuInS(2)/Mo structure also depended on the structural characteristics of the CuInS(2) films, i.e., preliminary conversion efficiencies of ca. 5% were obtained for devices based on the CuInS(2) films obtained after 110 °C pretreatment, whereas the device prepared by the CuInS(2) film without 110 °C pretreatment showed the conversion efficiency less than 1.5%.
40
Chalcopyrite thin film solar cells by electrodeposition
Daniel Lincot, Jean‐François Guillemoles, S. Taunier et al. · Solar Energy · 2004 · 381 citations
Efficient CuInS2 solar cells from a rapid thermal process (RTP)
Kai Siemer, Jo Klaer, I. Luck et al. · Solar Energy Materials and Solar Cells · 2001 · 333 citations