Simple CAD procedure for microwave filters and multiplexers

Abstract

The design of microwave filters and multiplexers requires a common step before actual hardware implementation, namely, the identification of a number of specific ideal electrical components with actual waveguide discontinuities. In the past, this step was accomplished semi-analytically using approximate single-mode discontinuity models. The complete filter or multiplexer could then be assembled, but additional final tuning or optimization with a large number of parameters was generally required. In this paper, we propose an alternative technique for the design of microwave filters or multiplexers that directly uses a full-wave electromagnetic simulator and that effectively decomposes the complex design task into a series of simple sub-tasks with clearly identified objectives. The procedure described only involves a limited number of actual physical parameters at each step so that it is computationally very efficient and rapidly convergent.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>