Use of a Silicone Rubber (Clear Seal) as a Section Adhesive Resistant to Acid, Alkali and Heat

Abstract

An optically clear silicone rubber adhesive is recommended for use in histochemical procedures in which detachment of tissue sections is likely. Procedure: Cut paraffin sections and float on a 45–50 C water bath; leave frozen sections on the microtome knife in the cryostat; spread the silicone rubber thinly and evenly over 2/3 of the slide (Clear Seal—General Electric, was used); pick up paraffin sections directly from the floatation water and frozen sections from the microtome knife with a warm slide; dry for 1.5 hr at 25 C; place paraffin sections in a 60 C oven for 0.5 hr, deparaffinize through xylene and hydrate through alcohols to water. Stain sections as desired, but avoid clearing agents before mounting after strong acid or alkaline treatment, and mount rapidly if a synthetic resin is used because of the solvent effect on the silicone rubber. Of the adhesives tried, silicone rubber is the only one capable of withstanding boiling 10% HCl for any period of time without detachment of sections.