2006 · 23 citations · 1 references
EngineeringCivil EngineeringPetroleum EngineeringDrillingDrilling EngineeringWell IntegrityDrilling HydraulicsDrilling MechanicsDrilling OperationsDrilling SafetyWell ControlWellbore HydraulicsDrilling DesignDrilling Through Overpressured FormationsHazard MitigationIntermediate Casing DesignManaged Pressure Drilling HydraulicsMud Weight CorrectionMud Weight DesignMud Weight Management
Abstract Is this the beginning of the end of weighted mud systems? An advanced well control practice called Managed Pressure Drilling (MPD) is staged to challenge the conventional drilling practice of when in doubt "weight it up". Formation overpressures have traditionally forced operators to weight-up mud systems in order to advance drilling operations while preventing formation fluids invasion. A direct consequence of increased mud weight is a dramatic reduction in drilling Rate of Penetration (ROP), requirement for additional casing seats/strings and increased well control risks due to kicks from losses. This drilling hazard has represented a major source of invisible or intangible lost time and hence, cost. A drilling hazard mitigation multi-well trial was carried out to investigate and quantify the reduction in ROP as a result of mud weight increases to overcome troublesome formation overpressures and associated High Pressure Low Volume (HPLV) nuisance gas. Without increasing mud weight to control overpressures, MPD technology was applied to safely and cost effectively drill through overpressures and avoid an intermediate casing string normally used to isolate a loss zone. MPD trial results examined in this paper addresses many of the issues and provides forward-looking statements regarding large-scale introduction of the system to other fields. The multi-well trial results showed a close match to the predicted MPD ROP curve, achieving an economically rewarding ROP gain of at least 2.5 times and gross well cost reductions of over 20%, without recordable troublesome zone Non-Productive Time (NPT). Initial concerns of borehole instabilities using lightweight mud with borehole pressures less than the adjacent pore pressure were not observed (in both vertical and directional well cases).
1
Egbert J. van Riet, Don Reitsma, B. Vandecraen · SPE/IADC Middle East Drilling Technology Conference and Exhibition · 2003 · 54 citations